ViewSonic M1+ G2 - Remote Control Effective Range; Replacing Remote Control Batteries

11
Remote Control - Eecve Range
To ensure proper funcon of the remote control follow the steps below:
1. The remote control must be held at an angle within 30° perpendicular to the
projector’s IR remote control sensor(s).
2. The distance between the remote control and the sensor(s) should not exceed 8
m (26 .)
Remote Control - Replacing the Baeries
1. To open the baery cover, turn the remote control over to view its back, open
the cover in the direcon of the arrow.
2. Remove any exisng baeries (if necessary) and install two AAA baeries
observing the baery polaries as indicated in the base of the baery
compartment. Posive (+) goes to posive and negave (-) goes to negave.
3. Replace the baery tray by aligning it with the base and pushing it back into
posion.
NOTE:
• Avoid leaving the remote control and baeries in excessive heat or a humid
environment.
• Replace only with the same or equivalent type recommended by the
baery manufacturer.
• If the baery is drained or if you will not be using the remote control for
an extended period of me, remove the baery to avoid damage to the
remote control.
• Dispose of used baeries according to the manufacturer’s instrucons and
local environment regulaons for your region.