ViewSonic N3752w
11
ENGLISH
Basic Setup
1. Power on the A/V component you wish to setup, so that you can test codes by
sending power off commands.
2. Refer to the Pre-programmed code tables on page 13-18 and write down the
code number listed.
3. Press and hold the button for the desire device for approximately six seconds.
The top LED will turn on, enter pre-programmed code. LED will blink to indicate
pre-programmed code was captured correctly.
Device Buttons
LED
Pre-Programmed Code Notes
Record the three digit codes for your device here:
VPB
WMA
AUD
AUX
TV
DVD
STB
VCR
To Next Page
Loading...
