ViewSonic PJ400 - Easy Menu

ViewSonic PJ400
25
EASY MENU
With the EASY MENU, items shown in the table below can
be performed.
Choose an item using the cursor buttons ▲/▼ on the
projector or remote control. Then perform it referring to the
following table.
Item Description
ASPECT Using the buttons ◄/► switches the mode for aspect ratio.
See the item ASPECT of section IMAGE menu. (19, 30)
ZOOM Using the buttons ◄/► adjusts the zoom.
See the item ASPECT of section SETUP menu. (19, 34)
KEYSTONE Using the buttons ◄/► corrects the keystone distortion.
See the item KEYSTONE of section SETUP menu. (20,34)
MODE Using the buttons ◄/► switches the mode of picture type. The
modes of picture type are combinations of a mode of GAMMA
(27) and a mode of COLOR TEMP (28). Choose a suitable
mode according to the projected source.
NORMAL  CINEMA  DYNAMIC
═══════════════
NORMAL: (COLOR TEMP = MIDDLE) + (GAMMA = #1
DEFAULT)
CINEMA: (COLOR TEMP = LOW) + (GAMMA = #2 DEFAULT)
DYNAMIC: (COLOR TEMP = HIGH) + (GAMMA = #3
DEFAULT)
• When the combination of GAMMA and COLOR TEMP differs
from pre-assigned modes above, the display on the menu for the
MODE is “CUSTOM”.
BRIGHT Using the buttons ◄/► adjusts the brightness.
See the item BRIGHT of section PICTURE menu. (27)
CONTRAST Using the buttons ◄/► adjusts the contrast.
See the item CONTRAST of section PICTURE menu. (27)
COLOR Using the buttons ◄/► adjusts the strength of whole color.
See the item COLOR of section PICTURE menu. (28)
• This item can be chosen only at a video signal.
TINT Using the buttons ◄/► adjusts the tint.
See the item TINT of section PICTURE menu. (28)
• This item can be chosen only at a video signal.
SHARPNESS Using the buttons ◄/► adjusts the sharpness.
See the item SHARPNESS of section PICTURE menu. (28).