Freezing the screen
1.
Press the FREEZE button on the remote control.
The “FREEZE” indication will appear on the screen, and the
projector will enter the FREEZE mode.
To exit the FREEZE mode and restore the screen to normal,
press the FREEZE button again.
● The projector automatically exits the FREEZE mode when the input signal
changes, or when one of the projector’s buttons or the remote control buttons
of STANDBY/ON, SEARCH, RGB, VIDEO, BLANK, AUTO, ASPECT, VOL
-
UME, MUTE, KEYSTONE, POSITION, MENU, MAGNIFY and MY BUTTON is
pressed.
● If the projector continues projecting a still image for a long time, the LCD panel
might possibly be printed. Do not leave the projector in the FREEZE mode for
too long.
Temporarily blanking the screen
1.
Press the BLANK button on the remote control.
The blank screen will be displayed instead of the screen of
input signal. Please refer to the BLANK item in the SCREEN
menu
.
To exit the blank screen and return to the input signal screen, press the
BLANK button again.
● The projector automatically returns to the input signal screen when one of the
projector’s buttons or the remote control buttons is pressed or one of the com
-
mands (except get commands) is transmitted from the control port.
Operating
To Next Page
Loading...
