Operation28
Fine-tuning the image clarity
Sharpen the image by rotating the focus ring.
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the
top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following one of these steps.
• Using the remote control
Press / on the projector or remote control to
display the Keystone correction page. Press to
correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the image.
• Using the OSD menu
1. Press MENU/EXIT on the projector or
Menu on the remote control and then press
/ until the
DISPLAY menu is
highlighted.
2. Press to highlight Keystone and press
MODE/ENTER on the projector or ENTER
on the remote control. The Keystone
correction page is displayed.
3. Press to correct keystoning at the top of
the image or press to correct keystoning at
the bottom of the image.
To Next Page
Loading...
Need help?
General