Maintenance72
7. Lift the handle so that it stands up. Use
the handle to slowly pull the lamp out
of the projector.
CAUTION
• Pulling it too quickly may cause the lamp
to break and scatter broken glass in the
projector.
• Do not place the lamp in locations where
water might splash on it, children can
reach it, or near flammable materials.
• Do not insert your hands into the projector
after the lamp is removed. If you touch the
optical components inside, it could cause
color unevenness and distortion of the
projected images.
8. Insert the new lamp into the lamp
compartment and make sure it fits in
the projector.
9. Reconnect the lamp connector and
place it back into its slot to be flush
with the projector.
10. Tighten the screw that secures the lamp.
CAUTION
• Loose screw may cause a bad connection,
which could result in malfunction.
• Do not over tighten the screw.
11. Ensure the handle is fully laid flat and
locked in place.
12. Place the lamp protection film supplied
with the new lamp on the lamp
compartment.
13. Replace the lamp cover on the
projector.
To Next Page
Loading...
Need help?
General