ViewSonic Pro8600 - Setting the Presentation Timer

22
Setting the presentation timer
The presentation timer can indicate the presentation time on the screen to help you achieve
better time management when giving presentations. Follow these steps to utilize this
function:
1. Go to the Setting > Presentation Timer menu and press ENTER on the projector
or Enter on the remote control to display the Presentation Timer page.
2. Highlight Timer Period and decide the timer period by pressing / . The length
of time can be set from 1 to 240 minutes in 1-minute increments.
Important
• If the timer is already on, the timer will restart whenever the Timer Period is reset.
3. Press to highlight Display Timer and choose if you want the timer to show up
on the screen by pressing / .
4. Press to highlight Timer Position and set the timer position by pressing /
.
Top-Left → Bottom-Left → Top-Right → Bottom-Right
5. Press to highlight Timer Counting Direction and select your desired counting
direction by pressing / .
6. To activate the presentation timer, highlight Presentation Timer and press /
to select On and press ENTER on the projector or Enter on the remote control.
To cancel the timer, perform the following steps:
1. Go to the Setting > Presentation Timer > Presentation Timer menu and
highlight Off.
Selection Description
Always Displays the timer on screen throughout the presentation time.
1 Min/2 Min/3 Min Displays the timer on screen in the last 1/2/3 minute(s).
Never Hides the timer throughout the presentation time.
Selection Description
Count Up Increases from 0 to the preset time.
Count Down Decrease from the preset time to 0.