Name: ViewSonic TD2430
Brand: ViewSonic
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Quick Installation

1. Connect video cable

• Make sure both the display and computer are turned OFF.

• Remove rear panel covers if necessary.

• Connect the video cable from the display to the computer.

Macintosh users: Models older than G3 require a Macintosh adapter. Attach the

adapter to the computer and plug the video cable into the adapter.

2. Connect power cord (and AC/DC adapter if required)

HDMI

DisplayPort

VGA

Audio In

USB UP

USB Down

Power Cord

Audio out

3. Turn ON the display and computer

Turn ON the display, then turn ON the computer. This sequence (display before

computer) is important.

NOTE: Windows users may receive a message asking them to install the INF file.

To download the file, visit the “Download” section of the monitor product page on

the ViewSonic website.

4. Windows users: Set the timing mode (example: 1024 x 768)

For instructions on changing the resolution and refresh rate, see the graphics

card’s user guide.

5. Installation is complete. Enjoy your new ViewSonic display.

Questions and Answers:

Need help?

Do you have a question about the ViewSonic TD2430 and is the answer not in the manual?

ViewSonic TD2430 Specifications

General