Fifth: Connect
Press “Connect” button. There will be a dialog which will say “entry ISP Mode!!” if monitor connected
to PC by hardware tools ok. Then press “確定”.
If you get a “can’t entry ISP Mode” message. You can try below solutions to conquer it.
(1). Check cable connected OK?
(2). Is selected a correspond device?
(3). Try to turn down ISP speed.
Last: Upgrade firmware to monitor.
Press the button “Auto”, then press “RUN”.
If download F/W successful, you can see it show Verify OK. If error. Please turn down ISP speed Run
again.
When update firmware successful, please press “Dis Con” button to disconnect.
That’s all .thanks.
ViewSonic Corporation Confidential - Do Not Copy VP930-3_VP930b-3
28
To Next Page
Loading...
