13
ENGLISH
Using the TV Features
Turning the TV On and Off
Press the POWER button on the remote control.
You can also use the Power button on the side of the panel.
Operation
Initial Setup
(Setup Wizard only appears when rst turning the TV on and without channel scanning.)
1. Press the POWER button on the remote control. The Setup Wizard window will be display.
2.Press ▲ or ▼ to select Home or Retail(See Figure1).
3. Press ◄ or ► to select OSD language, then press ENTER to conrm the
selection, and press ▼ to go to next step. To return to the previous page, press
MENU.(See Figure2)
4. Select TV Source from Air or Cable, then press ENTER to continue.
5. The Initial Setup will be completed after Cannel scanning is nished. To interrupt the
scanning, press MENU at any time. (See Figure3)
Figure 1
Figure 2
Figure 3
＊
If there is no input signal within 15 minutes, TV will be
turned off automatically.
To Next Page
Loading...
Need help?
General
