16
ViewSonic VT2405LED
ENGLISH
Using the TV Features
Turning the TV On and Off
Press the POWER button on the remote control.
You can also use the Power button on the side of the panel.
Operation
Initial Setup
(Setup Wizard only appears when fi rst turning the TV on and without channel scanning.)
1. Press the POWER button on the remote control. The Setup Wizard window will be display.
2. Press ◄ or ► to select OSD language, then press ENTER or ▼ to confi rm the
selection, and press ► or ENTER to go to next step. To return to the previous page, press
MENU.(See Figure1)
3. Press ◄ or ► to select your display mode from *Home, Medium, Low or High, then
press ENTER or▼ to confi rm the selection, and press ► or ENTER to go to next step. To
return to the previous page, press MENU. (See Figure2)
* For normal home use, we suggest that you select “Home” to achieve energy saving.
4. Select Time Zone of your location. To press ▼ to setup DST (Daylight Saving Time) and
select On or Off with ◄ or ►, according to the time zone of your area. To press ▼ to setup
Time Format, and select 12-hour or 24-hour with ◄ or ►, then press ENTER or ► to
continue. (See Figure3)
5. Select TV Source from Air or Cable, then press ENTER to continue. (See Figure4)
6. The Initial Setup will be completed after Cannel scanning is fi nished. To interrupt the
scanning, press MENU at any time. (See Figure5)
Figure 1 Figure 2
Figure 3 Figure 4
Figure 5
＊
If there is no input signal within 15 minutes, TV will be
turned off automatically.
To Next Page
Loading...
Need help?
General