4
•
may cause it to fail. If the projector does become wet, disconnect it from the
power supply and call your local service center to have the projector serviced.
•
•
other. A grounding-type plug has two blades and a third grounding prong. The
outlet.
•
•
plug, and at the point where it emerges from the projector.
• In some countries, the voltage is NOT stable. This projector is designed to
operate safely within a voltage between 100 to 240 volts AC, but could fail if
or cut out, it is recommended that you connect your projector through a power
• If smoke, an abnormal noise, or a strange odor is present, immediately switch
using the projector.
•
•
•
CAUTION:
with any bright light source, do not stare into the beam, RG2 IEC 62471-
5:2015
To Next Page
