Preset filter cycles The first filter cycle begins 6 minutes after the
spa is energized. The second filter cycle begins 12 hours later.
Filter duration is programmable at the topside control for 2, 4, 6,
8 hours, or 12 hours for continuous filtration, (indicated by “
FC”).
The default filter time is 2 hours. To program, press “Temp”, then
“Jets”. Press “Temp” to adjust. Press “Jets” to exit programming.
Note: The Secondary Pump purges for 30 seconds at the beginning
of each filter cycle. The low speed of the primary pump runs during fil-
tration and the ozonator (if installed) will be enabled.
FREEZE PROTECTION
Note: For all other diagnostic messages, please refer to
the SUV M-7 Control Reference Card that came with your
spa.
Warning! / Shock Hazard! / No User Serviceable Parts.
Do not attempt service of this control system. Contact your
dealer or service organization for assistance. Follow all
owner’s manual power connection instructions. Installation
must be performed by a licensed electrician and all
grounding connections must be properly installed.
18
To Next Page
Loading...
Need help?
General
