SPA STARTUP DIRECTIONS
All Viking Spas require a solid, flat surface.* This is to ensure that the
spa cabinet is not exposed to a pressure stress condition that may result
in cabinet damage and shell cracking. A concrete pad is the best
example of a solid, flat surface, however, wood decking is suitable, pro-
vided it can withstand 85# per sq. ft. without deflection.
* FAILURE TO PROVIDE A PROPER, SOLID, FLAT SURFACE
MAY DAMAGE YOUR SPA AND VOID YOUR WARRANTY.
The following procedure should be followed on initial startup and when-
ever the spa is drained for maintenance. Read each step in its entirety
before proceeding with that step.
FILL THE SPA WITH WATER
a. Clear all debris from your spa.
b. Remove filter element
c. Using a garden hose, place hose in filter chamber for filling. Do
not fill higher than three quarters of the way up the skimmer opening
d.
DO NOT use softened water.
e. As water level rises, check inside equipment compartments for
water leaks. It may be necessary to tighten loose unions and/or
fittings.
f. Make sure T-Handled Gate VALVES at pump and heater are open.
(Fully extended up position).
APPLY POWER
a. Apply power by tur
ning on the spa-dedicated cir
cuit br
eaker
.
b. Test the GFCI: push the TEST button and power is cut off. Push
RESET and power is r
estor
ed. If these do not seem to work,
STOP! Do not use your spa. There is no power, the
21
To Next Page
Loading...
Need help?
General
