Viking K-2000-DVA User Manual (English)

To Next Page

PRODUCT MANUAL

Designed, Manufactured and Supported in the USA

COMMUNICATION & SECURITY SOLUTIONS

Voice Alarm Dialing or Store Caster

Announcements from up to Eight Inputs

Features

Viking’s K-2000-DVA is a fully programmable

multi-input, multi-number auto dialer and digital

announcer, designed for emergency and non-

emergency message notification. The K-2000-

DVA has eight dry contact inputs, each of which

can dial up to eight 32-digit phone numbers and

play a message up to 1 minute in length specific

to that input.

Messages can be recorded locally or remotely with

a total message time for all 8 inputs of eight

minutes. When configured as an alarm dialer, the

K-2000-DVA has call progress detection capability

with normal and fast busy, call pickup, CPC and

ring-no-answer detection. The K-2000-DVA can

also be set up as a store caster (no dialing), for on-

site promotional or assistance announcements.

• Non-volatile memory (no batteries required)

• Stores up to eight 32-digit phone numbers per

input (sixty-four 32-digit numbers total)

• 8 minutes of record time (1 minute per input)

• Programmable message repeat counter

• Programmable lap counter

• Eight inputs programmable normally open or

normally closed and enabled or disabled

• Programmable ring delay for remote

programming and alarm polling

• Programmable qualifier timer for each input

(time for an event to be qualified as an alarm)

• Programmable resume timer for each input

(time following reset for input to become active again)

• Call progress detection

• Programmable ringback limit for call progress

• Remote security and access codes

• Store caster mode

• Local or remote programming and recording

• RS-232 port for programming via a PC

• Compatible with the Viking RC-2A and RC-3

remote DTMF controllers

• Phone numbers may be programmed as pager

numbers (no voice message played)

• Programmable hookswitch flash before dialing

• Line level input for loading pre-recorded

messages into the unit

Alarm Dialer

• Security/burglar/fire alarm notification

• System alarm or equipment malfunction notification

• Environmental warning notification

• Contacting personnel via numeric pagers

Store Caster

• Provide assistance or promotional announcements in

department stores, grocery stores, hardware stores,

gas stations, etc. ie: “Customer assistance needed

in aisle 13...”

Power: 120V AC/12V DC 500 mA, UL listed adapter

provided

Dimensions:

8.3” x 6.3” x 1.8” (211mm x 160mm x 46mm)

Shipping Weight: 1.02 Kg (2.25 lbs)

Environmental: 0°C to 32°C (32°F to 90°F) with 5% to

95% non-condensing humidity

Talk Battery: 12V DC

Touch Tone Dialing: 120 ms on/off, 50 ms on/off

CPC Detection Time: 320 ms minimum

Message Record Time: 8 minutes

Sampling Rate: 64 K (equivalent)

Input Detection Time: 80ms with Qualifier Timer set to 0

Resolution Qualifier Timer: 1 second to 18 hours

Resolution Resume Timer: 1 second to 18 hours

Connections: (1) RJ11 jack for telco connection, (2)

3.5mm jacks for 600-ohm audio output and record in, (1)

9 pin RS-232 for PC connection, (1) 13 position screw

terminal block for inputs

K-2000-DVA

Multi-Input Voice

Dialer/Announcer

August 26, 2015

Applications

Specifications

VIKING

Programming can be done with a touch tone

phone or using a PC with a serial port connection

and free software available on the Viking website:

www.vikingelectronics.com

Other manuals for Viking K-2000-DVA

Technical Practice8 pages

Application Note1 page

Supplementary Guide2 pages

Need help?

Do you have a question about the Viking K-2000-DVA and is the answer not in the manual?

Viking K-2000-DVA Specifications

General

Power	120V AC
Shipping Weight	2 lbs
Operating Temperature	32°F to 90°F (0°C to 32°C)
Maximum Talk Time	Not applicable
Maximum Number of Messages	Not applicable
Connections	RJ11
Compatibility	Compatible with analog phone lines
Type	Digital Voice Announcer
Amplification	Not applicable
Weight	1.5 lbs (0.7 kg)