Viking L-3 - Table of Contents

VIKING TECHNICAL SUPPORT 1.800.908.0884
5
PARTS DIAGRAM/PARTS LIST 2
OPERATOR REFERENCES 3
CONTROL BOARD REFERENCES 4
IMPORTANT SAFETY INFORMATION 6-12
Important Safety Instructions 6
Important Installation Instructions 7
Maintenance 8
General Safety Precautions 8-9
Operator Classification 9
Photo Beam (non-contact sensor) Installation 10
Edge Sensor (contact sensor) Installation 11
Manual Release 11
Audible Alarm Reset Installation 12
Warning Placard Installation 12
IMPORTANT INSTALLATION INFORMATION 13
Specifications 13
GATE OPERATOR INSTALLATION 14-17
Concrete Pad Option 14
Post Mounting Option 15
Operator Positioning 16-17
ELECTRICAL INSTALLATION 18-19
High Voltage Supply Option 18
Low Voltage Supply Option 19
Solar Supply Option 19
LIMITS SETUP 20-21
MASTER/SLAVE SET UP 22-23
Two Wire Communication 22
Wireless Communication (Bluetooth) Option 23
CONTROL BOARD SETUP 24-26
Initial Settings 24-25
Obstruction Detection Sensor (Primary Entrapment Protection) 26
ACCESSORY CONNECTIONS 27-32
Re-Open Photo Beam (Vehicular Safety) 27
Radio Receiver (Typical) 28
Anti-Tail Gate, Open Commands, Guard Station 29
Viking Loop Rack 30
Guidelines for Loop Installations 31
Magnetic Lock, Lock Solenoid 32
Barrier Arm (B-12) Synchronization Option 33
TROUBLESHOOTING 34-39
LED References 34-35
LCD Display References 36-38
Solutions 39
APPENDIX A, B & C 40-43
VIKING EXPANSION PRODUCTS 44
PARTS DIAGRAM/PARTS LIST
2
OPERATOR REFERENCES
3
IMPORTANT INSTALLATION INFORMATION
13
GATE OPERATOR INSTALLATION
14-17
ELECTRICAL INSTALLATION
18-19
LIMITS SETUP
20-21
MASTER/SLAVE SET UP
22-23
CONTROL BOARD SETUP
24-26
ACCESSORY CONNECTIONS
27-32
TROUBLESHOOTING
34-39
VIKING EXPANSION PRODUCTS
44
APPENDIX A, B & C
40-43
TABLE OF CONTENTS:
CONTROL BOARD REFERENCES
4
IMPORTANT SAFETY INFORMATION
6-12