To Next PageTo Next Page
Need help?Do you have a question about the Viking ME 339 and is the answer not in the manual?
This instruction manual constitutes original manufacturer's instructions in the sense of EC Directive 2006/42/EC.
VIKING supplies machines with different plugs and switches, depending on the country of sale.
Illustrations and texts describe specific operating steps. All symbols affixed to the machine are explained herein.
Safety regulations must be observed when working with the lawn mower. Read the manual before first use.
Place the machine on level ground and perform all operations described.
Steps to install the mono handlebar on the ME 339 C lawn mower.
Details on the adjustable telescopic handlebar for the ME 339 C.
Untangle knots in the cable immediately. Guide the electric cable behind you.
Safety precautions for mowing on inclines up to 25°.
Do not switch on the mower in tall grass or at lowest cutting height.
Switch off the motor immediately and disconnect the plug if the blade blocks.
The built-in thermal overload protection device automatically deactivates the motor.
The motor can only be switched on by pressing the start button and pulling the motorstop lever.
The mowing blade comes to a complete standstill in less than three seconds after releasing the lever.
Observe safety instructions. Ensure correct connection cord and mains voltage.
Strain relief prevents unintentional disconnection of the electric cable.
Press and hold start button, pull motorstop lever to handlebar.
Release the motorstop lever; motor and blade stop after a short run-down time.
The grass catcher box has a level indicator on the upper part.
Switch off motor, detach grass catcher box and empty it.
Observe safety instructions. Annual service by specialist dealer recommended.
Clean thoroughly after each use. Avoid spraying water on motor components.
The electric motor and wheel bearings are maintenance-free.
The upper handlebar is coated with an insulating layer; it must be replaced if damaged.
Check blade for damage, notches, cracks, wear. Measure blade thickness.
Only lift by transport handles. Ensure sufficient distance from blade. Secure on load floor.
Record model, serial number, and date of purchase for handover confirmation.
Hand manual to dealer for service operations confirmation in pre-printed boxes.
This instruction manual constitutes original manufacturer's instructions in the sense of EC Directive 2006/42/EC.
VIKING supplies machines with different plugs and switches, depending on the country of sale.
Illustrations and texts describe specific operating steps. All symbols affixed to the machine are explained herein.
Safety regulations must be observed when working with the lawn mower. Read the manual before first use.
Place the machine on level ground and perform all operations described.
Steps to install the mono handlebar on the ME 339 C lawn mower.
Details on the adjustable telescopic handlebar for the ME 339 C.
Untangle knots in the cable immediately. Guide the electric cable behind you.
Safety precautions for mowing on inclines up to 25°.
Do not switch on the mower in tall grass or at lowest cutting height.
Switch off the motor immediately and disconnect the plug if the blade blocks.
The built-in thermal overload protection device automatically deactivates the motor.
The motor can only be switched on by pressing the start button and pulling the motorstop lever.
The mowing blade comes to a complete standstill in less than three seconds after releasing the lever.
Observe safety instructions. Ensure correct connection cord and mains voltage.
Strain relief prevents unintentional disconnection of the electric cable.
Press and hold start button, pull motorstop lever to handlebar.
Release the motorstop lever; motor and blade stop after a short run-down time.
The grass catcher box has a level indicator on the upper part.
Switch off motor, detach grass catcher box and empty it.
Observe safety instructions. Annual service by specialist dealer recommended.
Clean thoroughly after each use. Avoid spraying water on motor components.
The electric motor and wheel bearings are maintenance-free.
The upper handlebar is coated with an insulating layer; it must be replaced if damaged.
Check blade for damage, notches, cracks, wear. Measure blade thickness.
Only lift by transport handles. Ensure sufficient distance from blade. Secure on load floor.
Record model, serial number, and date of purchase for handover confirmation.
Hand manual to dealer for service operations confirmation in pre-printed boxes.
General| Brand | Viking |
|---|---|
| Model | ME 339 |
| Category | Lawn Mower |
| Language | English |
