30
7:30 Ejection Position
Contamination—Motor will not oscillate Replace Ice Maker
Shut-off arm stuck in ice or obstructed Unjam
Cubes not formed properly Check fill cup and fill assembly
9:00 Ejection Position
Contaminated Replace Ice Maker
Cube frozen to fill cup or mold Unjam
Replace fill cup and replace Ice Maker
Excessive Ice Production
Problem Action
Shut-off arm not in actuator Replace shut-off arm in actuator
Deformed shut-off arm Replace shut-off arm
Broken shut-off lever or lever bypassing Replace Ice Maker
vertical cam
Broken module actuator Replace Ice Maker
Hollow Ice Cubes
Problem Action
Low water fill volume Adjust module screw, clear water path, or
replace water valve
Improper freezer air flow Direct air flow away from thermostat
Thermostat out of calibration Replace Ice Maker
To Next Page
Loading...
