Vimar 01910 Instruction Handbook

31 - ENGLISH
8. OPERATION
When the timer-thermostat has been programmed it can be set in
operation.
If the relay is on, the display will show the
symbol in the winter
(heating) or the
symbol in the summer (air-conditioning).
The
symbol indicates there is a TX radio module or no relay
module; wait for at most 2 minutes for automatic recognition or
do a reset.
•Settingmanualoperation
- If the timer-thermostat is working in automatic mode, press the
button to pass onto manual mode; the display will show the
.
- Using the
button, select the desired temperature then press the
button to confirm.
If necessary, wait approximately 5 seconds for the operation to be
confirmed.
•Settingautomaticoperation
- If the timer-thermostat is working in manual mode, press the
button to pass onto automatic mode; the display will show the
histogram for the program’s day selection.
In this case it is possible to pass onto manual mode temporarily,
for example when the desired temperature is not the programmed
temperature, by selecting the setting with the
button and waiting
approximately 5 seconds for the operation to be confirmed.
The new setting will remain active until the next programmed temper-
ature level change, after which the saved program will be restored.
To go back onto automatic operating mode immediately, press the
button.

Vimar 01910 Specifications

General

Brand	Vimar
Model	01910
Category	Thermostat
Language	English