20
42920.P
Reset button
- set the relay activation time in the event it is activated by
the exit button or by the Mifare key.
Note that the setting of the relay activation time must also be
repeated in the apartment stations.
Should the relay be activated from an indoor station, the
activation time can be set from the indoor station itself.
Should the relay be activated by a Mifare key or exit button,
then the activation time also needs to be set on the outdoor
station too.
1) With the front not installed, press the reset button on the
sequence of 2 (two) beeps and the call button LEDs will
2) In this status, press the call button in the top left corner,
to set the relay activation time if activated via Mifare key
or exit button.
If no buttons are pressed, the time will be set to 1s by
default
Depending on the number of times the button in the top
left corner is pressed, the time indicated by the following
3) The procedure ends after 4s of inactivity
the end of the procedure.
1) With the front not installed, quickly press the reset button
key for addition”.
We recommend marking the key with “key for addition”
“administration key for removal”.
We recommend marking the key with “key for removal”.
The administration keys and all user keys can be reset by
repeating the above procedure from the beginning.
4) If no other action is carried out, the registration procedure
will end after 5 seconds with a warning tone (4 beeps).
keys will be possible, repeating the above procedure from the
beginning.
The front case can now be installed on the outdoor station,
taking care to close the anti-tamper key.
Adding a user key
For the addition and removal of user keys, the front of the
outdoor station does not necessarily have to be opened. These
installation.
1) Bring the “administration key for addition” up to the RFID
2) Bring an unprogrammed key up to the reader. The device
will enable it as a “user key”. The device will beep when the
3) Repeat step 2) to add any other keys.
4) The procedure for enabling user keys will end after about 5
s of inactivity.
end of the procedure.
The keys added using this procedure will immediately be
Removing user keys
A user key can only be removed using the actual key itself, as
1) Bring the “administration key for removal” up to the RFID
2) Bring a user key up to the reader. The device will disable it.
3) Repeat step 2) to remove any other keys.
4) The procedure for disabling user keys will end after about 5
s of inactivity.
The device will beep 4 times to indicate the end of the
procedure.
Key reading
To read a key, simply place it on the outdoor station reader,
].
the key is not recognised, the outdoor station will beep twice.
If the key is kept in place for a short time of up to 2 s, the
electrical lock will be activated.
If the key is kept in place for longer than 3 s, another beep will
sound and the relay will be activated.
To Next Page
Loading...
