16
Contents
Previous
Page
First
Page
Next
Page
Previous
View
3.4 Fully slacken the skid clamp (10).
3.5 On the telescopic column depress the top stage (17) to its lowest point and engage the safety
latch (2).
3.6 Ensure the bottom clamp (15) is engaged and the control valve (18) is set to the 'Work' position
(Fig 2.1).
3.7 Release the Velcro retaining strap (5).
3.8 Hold the telescopic column upright with the steering ring uppermost and swing the three leg ties
up almost to horizontal.
3.9 Lift the column assembly by the steering ring and lower it vertically into the skid centre casting.
Engage the leg ties on the foot supports add secure with the rubber strap (6).
3.10 Tighten the skid clamp (10).
3.11 Secure the Velcro retaining strap (5) clear of the wheels.
3.12 The pedestal is now assembled and must be pressurized before a load is fitted.
Fig 2.1 Control Valve
INTERMEDIATE PUMPBLEED WORK
To Next Page
Loading...
