VIO 7 Vio - LED Status Indicator; Installation; Supplied Components List; Initial Implementation

11
Rev. 1 20.12.2019
EN
 LED
All the instruments are equipped with a two-colours LED (red and green) which provide the user with
important information on the status of the system:
Function
LED
Description
Power on
Fixed
Power off
Fixed
Standby
Flashing every 20 s
Measure stable
Flashing every 3 s
Errors during calibration
Flashing every 1 s
Errors during measurement
Flashing every 3 s
Selection confirm
Switched on for 1 s
Timed screens
Fixed
DHS deactivation
Fixed
Installation
 Components supplied
The instrument is always supplied inside the specific transport case; in the version without sensor it
is always present:
Instrument with batteries, 1m S7 / BNC connection cable, NT55 temperature probe, buffer solutions in
single-dose bottle and / or sachet, paper tissues, screwdriver, beaker, electrode holder support -only for
multiparameter- multilingual user manual and test report.
Versions with the sensors(s) already included are also available. Contact your local distributor to be updated
on the correct composition of the sales kit.
 Implementation
 The device leaves the factory ready to be used by end-user.
 Batteries are included.
 Turning On and Off
Turn on the system by pressing the button . The display initially activates all segments and then
appears:
 model and firmware of the instrument;
 settings relating to the most important parameters and any information on the DHS sensor, if connected;
 the instrument switches on to the last parameter that was used;
 to switch off the instrument, press the key , while into measure mode.