14
3.3 Setup
3.3.1 MIC connection
3.4 Auto-calibration
- Make sure
o Speakers & Subwoofer are turned ON
o No inputs are connected to Neo
o Speakers are in Line of sight with Microphone
- Turn ON Neo
- Press the following sequence of buttons on the Remote and follow the display instructions.
Menu OK Up/Down till Calibrate OK.
- Keep complete silence
- After a while, the number of Speakers & Subwoofer that have been powered on will be
displayed. Please confirm pressing the OK key. Else press the MENU key and redo the
Calibration.
- After this confirmation, the Speakers & Subwoofer would generate a set of sweep sound and the
number of speakers & subwoofer will be re-checked. If during this process any Speaker or
Subwoofer is not detected it is reported. Then please redo the Calibration.
- After this confirmation, the Speakers & Subwoofer would generate another set of sweep sound
and follows it up with a period of silence during which the system would be completely
calibrated.
- Information about the setup (speaker location, angle and distance) would now be available to
the user. Check them. If duplicate speakers are reported (eg: 2 Front left with same parameters),
then check that the MIC cable is inserted properly and RE-CALIBRATE.
To Next Page
Loading...
Need help?
General