10
Section 7: Basic Operation
1. Insert one end of the DP cable into your PC’s graphics card. An HDMI cable may also be
used. HDMI cable not included.
2. Connect the other end of the cable to the corresponding connector on your monitor.
Audio Output
DP Connectors USB Port
HDMI Connectors Power Connector
3. Connect the power cable to your monitor then connect the other end to your power
source. It is recommended that you use a surge protector with adequate voltage if a wall
outlet cannot be reached directly.
4. Locate the power button on the monitor and press it to turn the monitor on.
AMD FreeSync
This feature is off by default. To activate, you must have hardware with FreeSync capability, a
DP or HDMI cable, and the latest graphic drivers. After connecting your computer and monitor
with a DP or HDMI cable, you may receive a prompt to enable the feature on your computer.
If you do not, you may need to enable the function in your graphics card menu. See your
graphics card manufacturer’s documentation for instructions.
If you use HDMI to connect, you must use the HDMI 2.0 port to be able to use FreeSync.
Section 8: Indicator Light
Indicator light
Solid blue light indicates power is on and the monitor is operating normally. Flashing blue light
indicates no video source, no horizontal or vertical signal has been detected or power is low.
Please ensure your computer is on and all video cables are fully inserted and/or connected.
To Next Page
