VIPA 315SB/DPM - Parameters for DP; Parameters for MPI;DP

n Level of protection: Here 1 of 3 protection levels may be set to
protect the CPU from unauthorized access.
– Protection level 1 (default setting):
No password adjustable, no restrictions
– Protection level 2 with password:
Authorized users: read and write access
Unauthorized user: read access only
– Protection level 3:
Authorized users: read and write access
Unauthorized user: no read and write access
5.8.3
Parameters for DP
The properties dialog of the PROFIBUS part is opened via a double
click to the sub module DP.
n Short description: Here the short description "DP" for PROFIBUS
DP is specified.
n Order no.: Nothing is shown here.
n Name: Here "DP" is shown. If you change the name, the new
name appears in the Siemens SIMATIC Manager.
n Interface: The PROFIBUS address is shown here.
n Properties: With this button the properties of the PROFIBUS DP
interface may be preset.
n Comment: You can enter the purpose of the PROFIBUS interface.
n Diagnostics: A diagnostics address for PROFIBUS DP is to be
preset here. In the case of an error the CPU is informed via this
address.
n Operating mode: Here the operating mode of the PROFIBUS part
may be preset. More may be found at chapter "Deployment PRO-
FIBUS Communication".
n Configuration: Within the operating mode "DP-Slave" you may
configure your slave system. More may be found at chapter
"Deployment PROFIBUS communication".
n Clock: These parameters are not supported.
5.8.4 Parameters for MPI/DP
The properties dialog of the MPI interface is opened via a double click
to the sub module MPI/DP.
n Short description: Here the short description "MPI/DP" for the MPI
interface is specified.
n Order no.: Nothing is shown here.
n Name: At Name "MPI/DP" for the MPI interface is shown. If you
change the name, the new name appears in the Siemens
SIMATIC Manager.
n Type: Please regard only the type "MPI" is supported by the VIPA
CPU.
n Interface: Here the MPI address is shown.
Protection
General
Address
General
VIPA System 300S CPU Deployment CPU 315-2AG13
Setting standard CPU parameters > Parameters for MPI/DP
HB140 | CPU | 315-2AG13 | GB | Rev. 14-40 47