Viper 1002 - One-Time Bypass

16
© 2006 directed electronics
To enter or exit Valet Mode using the remote control:
1. Open any vehicle door.
2. Press .
3. Press
or .
4. Press again.
The status LED will light solidly if you are entering Valet Mode,
and it will go out if you are exiting Valet Mode.
one-time bypass
This feature (if programmed On) stops the alarm from arming or
activating any outputs that are programmed to activate when the
alarm is armed.
One-time bypass will defeat the following actions:
Passive arming: If programmed ON the alarm will not arm
itself.
If the remote is used to arm the alarm after exiting the vehicle:
Window roll up: If programmed ON this output will not
activate.
Linked Auxiliary Outputs: If programmed to activate on
arm, they will not activate.
To activate one-time bypass:
1. After parking turn the ignition off.
2. Turn the ignition On for more than 1-second and less than
3-seconds and then turn Off.
3. The siren will chirp once to indicate one-time bypass has
been activated.
➜