To Next Page
J
jonathan34Aug 9, 2025
Why is the recovery water vacuuming insufficient in my Viper Floor Machine?
- CChad ColonAug 9, 2025
If the recovery water vacuuming is insufficient in your Viper Floor Machine, several issues could be the cause: * The recovery water tank might be full, in which case you should empty it. * The hose could be disconnected from the squeegee; ensure it is properly connected. * The vacuum grid might be clogged, or the float could be stuck closed; clean the grid and check the float. * The squeegee might be dirty, or the squeegee blades might be worn or damaged; clean and inspect the squeegee. * The tank cover might not be properly closed, the gasket might be damaged, or the standpipe tube might be clogged; ensure the cover is correctly closed, replace the gasket if needed, and clean the bend tube. * The vacuum hose could be clogged; clean the hose.
General
