COMPUTER INSTRUCTION
OPERATION
4. Manual Mode
(1) Turning and pressing encoder can adjust the LEVEL value which would ash until setting down. The
default value is LEVEL 1. (see g. 4-1)
(2) The value is not running cyclically as adjusting.
(3) After START user still can adjust MANUAL LEVEL and matrix display LEVEL and value. In three seconds
without any entry then would display WATT value.
(4) Turning and pressing encoder can adjust other values (as TIME, DISTANCE, CALORIES, PULSE) those
values would run cyclically. (see g. 4-2)
(5) After START only can operate the function. RPM BAR and PULSE BAR values would change. Pressing
STOP KEY could stop and all values would remain (HR signal would not eect). Pressing RESET KEY could
return to PROGRAM SELECT. (see g. 4-3)
To Next Page
Loading...
