COMPUTER INSTRUCTION
OPERATION
7. WATT mode
(1) WATT target. (default: 120)
(2) Turning and pressing encoder can adjusting WATT value.
(3) Then after START user still can exercise by setting WATT LEVEL and would adjust automatically. (4)
After START user still can adjust WATT value.
8. User Program Mode
(1) Automatically loaded the U1-U4.
(2) Turning and pressing encoder user can set the program (the 8 LEVEL values) that each would ash
until setting down. If user wants to stop setting, pressing encoder for 2 seconds, then the value would be
the same as last setting.
To Next Page
Loading...
