What to do if ViscoTec preeflow plug n dose Control Unit cannot be operated and LED is flashing?
If the ViscoTec Control Unit cannot be operated, the LED is flashing, and a fault signal is output (PIN 3), it could be due to an overcurrent shutdown. To resolve this, clean the dispenser. If the issue persists, consider replacing the stator. Consult the dispenser operation and maintenance manual for detailed instructions.
Guidelines to avoid damaging the dosing control unit and dispenser during operation.
Identifies potential hazards, specifically electric shock from defective equipment.
Details the wiring connections and functions for system plug 1.
Step-by-step instructions for connecting and preparing the unit for operation.
Explains how the control unit operates based on signals from the master control unit.
Provides guidance for diagnosing and resolving common faults.
General| Model | plug n dose |
|---|---|
| Input Voltage | 24 VDC |
| Supply Voltage | 24 VDC |
| Manufacturer | ViscoTec |
| Brand | ViscoTec preeflow |
| Function | Control of volumetric dispensing |
| Communication Interface | RS232 |
| Control Interface | RS232, Digital I/O |
To Next Page
