7 / 16INST-002766 / A plug´n´dose
2.5 Preventing damage to equipment
In order to prevent damage to equipment and to ensure precision dosing, note that
• The dispenser connecting cable may only be connected and disconnected when the
power supply is switched off.. The electronics in the drive motor could be damaged if this
precaution is not taken.
• Only use the original enclosed connection cables between the dispenser and the dosing
control. The connecting cables must not be extended or shortened. This can lead to
damage to the controller.
• the dispenser must never be operated without material (the stator will be destroyed).
2.6 Organisational safety measures
The necessary personal protective equipment must be provided by the operating
organisation. Personal protective equipment must be worn when carrying out all work and
procedures.
To ensure the provision of suitable personal protective equipment, the safety data sheet for
the conveyed material must be observed. Specifications for e.g. cleaning products and
lubricants must also be checked and observed.
All personal protective equipment must be checked to ensure it is working properly before
starting work.
Eye protection Hand protection Body protection Foot protection
SAFETY
To Next Page
Loading...
Need help?
General
