DB-3 Drawbar Organ
3.2 THE REAR PANEL
2
1
3 4 5
6
1. [POWER ] Switch: instrument on/off switch.
2. [AC ADAPTOR] connector: socket for connecting the external power supply adapter
supplied with the instrument.
3. PEDAL Jacks: these Jacks allow you to connect the pedals for controlling:
- [SLOW/FAST]: the speed of the Rotary effect (footswitch pedal).
- [MEMORY]: cyclic selection of the last Upper Memory selected or of the manual
drawbar setup (footswitch pedal).
- [VOLUME]: the instrument’s general volume (swell pedal).
4. [PITCH] Trimmer: this control allows you to regulate the instrument’s fine tuning. In
the central position, A is 440 Hz.
5. MIDI Connectors: five-pin DIN sockets for connecting remote MIDI units, as follows:
- [MIDI IN]: connector for receiving MIDI messages from a remote unit.
- [MIDI OUT]: connector for transmitting the MIDI messages generated by the
DB-3.
- [MIDI THRU]: connector for transmitting the MIDI messages received by the
[MIDI IN ] port.
6. OUTPUT Jacks: the [L/Mono] and [R] jacks allow you to connect the instrument to an
amplification system, speakers with amplifier or mixers. To use a monophonic signal,
connect to the [L/Mono] jack only. The [HEADPHONES] jack allows you to connect a
headphone set.
35
To Next Page
Loading...
