VISICO FT-650RX - Operation Button; Power Supply Connections; Set Language

05/06
OperationButton
Button Operation
SET
Press SET button to switch to
SETUP interface
MODE
Repeatedly press to select CCT
mode, HSI mode, effect mode and
Pixel Fx mode.
(Pixel Fx mode only with FT-650RX)
Press UP or down button, to change
function options.
Rotate Regulator to select language,
select effects or change parameter.
PowerSupplyConnections
1. Use with AC adapter：Plug the supplied AC adapter cable into the
AC adapter port[2] and screw the cap shut. Slide the power switch
[1] to I side (AC) to switch on the LED light.
2.Use with battery (not inlcude): Place two NP-F970 lithium batteries
on the battery compartment. Slide the power switch [1] to II side (DC)
to switch on the LED light.
Note: When removing the battery, please press and hold the battery
release button [6] first to avoid damaging the battery compartment.
When the battery power is low, please charge it in time to prolong
the battery life.When the battery and adapter are connected to the
LED light at the same time, the battery will not be charged. Battery
charging needs to use a charger.
SetLanguage
The default factory setting is English. Press SET button ,then
press to ENG.
Rotate regulator to change from English to Chinese