TVD Series Multifunction Scale Operation Manual
5.7.5 To disable check weighing mode
1 Press the key to display current limits.
2 Press the key to enter zero into both limits when the current limits are shown,
3 Press the key to store the zero values.
Notes
Check weighing available only when weight more than 20d
The function is not valid when one enters a lower limit greater than the upper
limit.
When lower limits are the same with upper limits,display only shows one set
value.
5.8 Accumulation
TVD can set to accumulate manually by pressing key or automatically.Before
operation scale should be stable and return to zero, accumulation available only when weight
more than 20d
To set the accumulation function to turn on, select the parameter ACC>ON
Note: Accumulation function can operate only in weighing mode.
5.8.1 Manual Accumulation
In the normal weighing mode, ensure display is zero and stable indicator is on.
1 Place the items on the platform and press key, when the display get stable
2 Display will be show ACC 1 and will show the total of the accumulation
3 The data will be sent to printer or PC if connected with printer or computer
4 Remove the weight from the pan for to get display zero and stable for the next
accumulation.
5 Scale should be get stable and zero for the next accumulation.
It can continue 99 operations or until to reach the maximum value of display.
5.8.2 Recall Memory
Press key, when the display in the normal weighing mode, display will be show the
accumulation times and will show the total values. These display will be show only two
seconds.
To Next Page
Loading...
Need help?
General
