Vision 1624R User Manual

Vision 1624R, 2525 and 2550 Series 5 Installation Guide4
© 2019 Vision Engraving & Routing Systems
1 Introduction
This guide contains information to prepare the owner of a Vision 1624R, 2525 or 2550 for the proper
installation of their machine. It is the customer's responsibility to read through this guide and make sure
the work area, electrical and computer requirements are met. If for any reason, there are questions about
these requirements, please call your Vision representative as soon as possible.
In the following sections, the complete machine and Vision software installation will be outlined.
Please call or email your Vision distributor or the Vision service department at Vision for assistance if
you have any questions with this procedure. The Vision service department phone number is 1-602-439-
0600 and the email address is service@visionengravers.com.
FOR MORE DETAILED INFORMATION, PLEASE REFER TO THE USER GUIDE FOR YOUR MACHINE
INSTALLED WITH THE VISION SOFTWARE. USER GUIDES ARE ALSO AVAILABLE ONLINE AT
http://www.visionengravers.com/support/vision-engraver-manuals.html
1.1 Computer Requirements
Minimum System
Requirements:
CPU:
Intel i5 2.6-3.0GHz
Hard Drive:
256 GB free space
RAM:
8 GB
Operating System:
Windows 10 (32/64 bit)
Windows 8 (32/64 bit)
Windows 7 (32/64 bit)
NOTE: Windows updates must ALL be installed
Ports:
1 USB port for security dongle
1 USB port for Ethernet adapter to connect machine
Suggested System
Requirements
CPU:
Intel i7 2.6-3.0GHz (or faster)
Hard Drive:
500 GB SSD (or larger)
RAM::
16 GB (or more)
Operating System:
Windows 10 (64 bit)
Ports
1 USB port for security dongle
1 USB port for Ethernet adapter to connect machine

Vision 1624R Specifications

General

Brand	Vision
Model	1624R
Category	Engraver
Language	English