Name: Vision TC2-AMP3
Brand: Vision
Rating: 4 (1 reviews)

To Next Page

To Previous Page

TC2-AMP3_manual_en.doc

NOTE 1: The speaker cable must be unshielded with a gauge of no less than 0.75mm.

THE WARRANTY WILL BE VOID IF YOU USE UNSUITABLE SHIELDED CABLE.

NOTE 2: THIS IS A LOW-IMPEDANCE AMPLIFIER. DO NOT ATTEMPT TO CONNECT 100V

LINE SPEAKERS (Normally any speakers with “t” in the part code)

Alternative Configuration

1. Techconnect

2. TC2-AMP3 module

3. UK Single gang Surround

4. Power cable

PROGRAMMING MEMORY

The Techconnect Amplifier turns on automatically when mains power turned on.

The amplifier has an adjustable memory:

Mode 1: Assumes a pre-set input and volume

Mode 2: (default) Resumes last input and volume

To view current mode and switch mode:

1. Turn amplifier off

2. Hold down volume+ then power buttons for 5 seconds. Input indicator will flash 8 times

showing current mode.

3. To change mode repeat step 2. Input indicator will flash 8 times showing the other mode.

4. Turn mains power off to apply change to memory.

Questions and Answers:

Need help?

Do you have a question about the Vision TC2-AMP3 and is the answer not in the manual?

Vision TC2-AMP3 Specifications

Power

Audio

Physical Characteristics