11
Indicator of Card Reader Control Output (Invalid
Card Output)
Card Reader Buzzer Control Output
Wiegand Head Read Data Input Data1
Wiegand Head Read Data Input Data0
Note:
The Alarm input hardware interface is normally open by default. So only the normally open
signal is allowed. It can be linked to the buzzer of the card reader and access controller,
and the alarm relay output and open door relay output.
For single-door access controller, the Wiegand card reader 1 and 2respectivelycorrespond
to the entering and exiting card readers of door 1. For two-door access controller, the
Wiegand card reader 1 and 2respectivelycorrespond to the entering and exiting card
readers of door 1 , and the Wiegand card reader 3 and 4respectivelycorrespond to the
entering and exiting card readers of door 2. For single-door access controller, the Wiegand
card reader 1, 2, 3 and 4respectivelycorrespond to the entering card readers of door 1, 2, 3,
and 4.
Chapter 4 External Device Wiring
4.1 Card Reader Wiring
Figure 4-1 Wiring diagram of Wiegand card reader
To Next Page
Loading...
Need help?
General