Vitamix S30 - Blending in the 1.2 L (40 ounce) Container; Safety Warnings for Hot Liquids; Step-by-Step Blending Guide

BLENDING IN THE
1.2 L (40 OUNCE) CONTAINER
1. To begin, put a seal onto the bottom thread of the blade
base. The seal should fit snugly and evenly around the thread.
WARNING
Parts will become hot with extended use.
DO NOT touch the drive socket in the underside of the blade base or the drive spline
inside the motor base.
When blending hot liquids in the 1.2 L (40 ounce) container, escaping
steam, splashes or contents may scald.
To secure the contents, lock the lid and lid plug securely in place prior to blending hot
liquids in the 1.2 L (40 ounce) container.
Rotating blades can cause severe injury.
DO NOT reach into container while machine is running.
To avoid damage or personal injury, DO NOT use the 1.2 L (40 ounce)
container (including the blade base, seal, lid and lid plug) in the microwave.
SCALE 1.000
Seal
Blade Base
2. Thread the blade base onto the 1.2 L (40 ounce) container in
a clockwise direction just until tight. Do not overtighten or
leaking can occur.
10
Liquids (water, juice, yogurt)
Fruits and Veggies
Leafy Greens
Ice and Frozen Ingredients
Dry Goods
(grains, seasonings, powders)
40 ounce (1.2 L)
Container
3. Load the 1.2 L (40 ounce) container according to
the recipe.
4. Put the lid onto the 1.2 L (40 ounce) container.
Make sure that the tabs on the lid snap onto
the container.
5. Insert the lid plug into the opening in the lid.
Turn the lid plug anti-clockwise to lock. Pull up
on the lid plug to make sure it is secure.
6. With the variable-speed control pointed at
stop (O), set the 1.2 L (40 ounce) container onto
This icon corresponds to suggested recipes for the 1.2 L (40 ounce) container in your cookbook.
Blade Base
the motor base with the container handle facing you. The interlock tabs on the 1.2 L (40 ounce) container
will lower into the cutouts in the motor base.
7. Begin blending by slowly turning the variable-speed control to the desired variable-speed setting or left
of center to pulse. Follow the recipe guidelines to finish the blend.
8. Wait until the blades come to a complete stop before removing the lid or the container from the
motor base.
9. Empty the container. Unthread the blade base from the container in a anti-clockwise direction.