vitapur advance - User Manual

Questions and Answers

C
Christine HenryAug 1, 2025
What to do if my vitapur advance unit is leaking water?
- T
  Terry LeonardAug 1, 2025
  If your Vitapur Water Filtration System is leaking water, several factors could be the cause. First, check for misaligned or cross-threaded connections on the inlet/outlet ports; reinstall them to ensure a solid connection. Second, excessive water pressure could be the issue; in this case, install a pressure regulator ahead of the system. Finally, water hammer causing pressure spikes might be the cause; install a water hammer arrestor in the system.
S
Sarah Price MDAug 6, 2025
Why is my Vitapur Water Filtration Systems vibrating?
- R
  Renee GrantAug 6, 2025
  If your Vitapur Water Filtration System is vibrating, there are a few potential causes. First, ensure the system is securely mounted by tightening the fasteners. Second, water hammer could be causing vibrations, so install a water hammer arrestor in the system. Finally, make sure the system has enough space for cooling, with a minimum of 6-12” / 15-30 cm clearance around the unit.
A
Ana TerrellAug 11, 2025
What to do if my vitapur advance Water Filtration Systems has power but the UV lamp is not coming on?
- J
  Joseph SmithAug 11, 2025
  If your Vitapur Water Filtration System has power, but the UV lamp isn't coming on and the alarm is activated, there are a couple of things to check. First, make sure the lamp is installed correctly and the electrical fitting is snug. If it is, the lamp may have failed and needs to be replaced.
T
tannerolsonAug 16, 2025
Why is my Vitapur Water Filtration Systems generating excessive heat?
- A
  Amber MeyerAug 16, 2025
  If your Vitapur Water Filtration System is generating excessive heat, it could be due to a couple of reasons. First, the unit might be operated in an excessively high ambient temperature; unplug it until the temperature is within ambient operating conditions. Second, the water temperature might be too high; make sure the treatment is only on the cold water side, before the water is heated.
J
Jason MccartyAug 21, 2025
How to fix no power to UV lamp in Vitapur Water Filtration Systems?
- J
  Julia ReyesAug 21, 2025
  If there is no power to the UV lamp of your Vitapur Water Filtration Systems when the system is plugged in, the GFCI wall socket may be tripped. Reset it following the manufacturer’s instructions provided with the outlet.
T
Theresa MaciasAug 27, 2025
How to resolve water sitting in UV reaction chamber in vitapur advance Water Filtration Systems?
- T
  Tyler WagnerAug 27, 2025
  If you observe water sitting in the UV reaction chamber of your Vitapur Water Filtration Systems, it may be due to warm water output and heating up because of infrequent use. To resolve this, run the tap for a short period of time.