To Next PageTo Next PageWhy is the sound and picture on my Vivax LED TV distorted or wavy?
The distortion or wavy picture on your Vivax LED TV might be due to interference from another electrical appliance. Try turning off nearby appliances; if the interference stops, move the appliance further away from the TV. If that doesn't work, try plugging the TV into a different power outlet.
What to do if my Vivax LED TV remote control does not work?
First, make sure that your Vivax LED TV is still receiving power and is operational. If it is, try replacing the batteries in the remote control. Ensure that the new batteries are installed correctly, according to the polarity markings.
What to do if I connected an external source to my Vivax LED TV and I get no picture and/or sound?
Check both the output connection on the external source and the input connection on your Vivax LED TV to ensure they are correctly matched. Also, verify that you have selected the correct input mode on the TV for the incoming signal.
Why is there a horizontal/vertical stripe on the picture, or why is the picture shaking on my Vivax 32S60T2S2SM?
The horizontal or vertical stripes, or a shaking picture on your Vivax LED TV, might be caused by a nearby interfering source, such as another appliance or an electric tool. Check for any such devices and move them away from the TV.
What to do if picture is normal, but no sound on Vivax LED TV?
First, check the volume settings on your Vivax LED TV. Also, make sure that the Mute mode is not turned on.
How to troubleshoot no sound or picture on Vivax LED TV?
If your Vivax LED TV shows no sound or picture, first ensure the power cord is securely plugged into a working AC outlet. Then, check that the power switch on the bottom right edge of the front panel is turned on. Finally, press the POWER button on the remote to take the unit out of Standby mode and check if the LED light is red or blue, indicating power is on.
Why is there sound but no picture on my Vivax LED TV?
If your Vivax LED TV has sound but no picture, or the picture is in black and white, try these steps. First, unplug the TV from the AC outlet and plug it back in after 60 seconds. If that doesn't work, check that the Colour setting is set to 50 or higher. You might also want to try different TV channels.
General
