Vivid Veloblade Volta - Page 6

5
RCT/PRCT:
Remove the locking the screw and cap [Figure 2.2] and place the tool in the
holder. Ensure the tool is pushed all the way into the holder to the lip on the
tool [Figure 2.3] and reattach the locking screw and cap.
For blade changing please see chapter 7.
PCTT:
To remove the crease tool pull down on the crease wheel [figure 2.4 & 2.5], to
reinsert place the wheel into the slots and push upwards [figure 2.6].
Figure 2.2
Figure 2.3
Figure 2.4
Figure 2.5
Figure 2.6