Need help?Do you have a question about the Vivid Veloblade Volta and is the answer not in the manual?
Turn on the machine, ensure switches are up, and open the software.
Load sheet media onto the feed table, ensuring correct positioning.
Thread roll material around the idle bar and onto the cutting bed.
PCTT is the Crease tool used in Position 1.
RCT is the Rotary cutting tool for materials up to 2mm.
PRCT (Pen tool) and RCT (Rotary cutting tool for kiss cutting).
Use Debug View to set tool position and perform a test cut (T-depth).
Alter the cutting speed in the tool configuration for desired results.
Manually adjust blade depth for PRCT/RCT tools for through or kiss cuts.
Modify crease pressure using air or mechanical settings for the crease wheel.
Overview of CCD Window for modes and Debug View for manual controls.
Output window shows errors and status; Historic tasks save previous cut files.
Edit, move, rotate, and adjust artwork using various software tools.
Change tool, linetype, and set cutting depth (stepping) for precise cuts.
Import desired artwork and select appropriate tools for cut lines.
Use Board CCD mode for printed material with registration marks.
Use Roll CCD mode for printed rolls with registration marks.
Use Direct Cut mode for material without registration marks.
Unscrew the tool, remove the old blade, insert a new one, and reassemble.
Regularly drain the compressor by unscrewing the drain valve.
Clean and relubricate linear bearings on the feeder and head.
Clean the cutting belt regularly using a brush or vacuum.
To Next Page
General