VivoLink VLHDMIMAT8X8 - CLEAR Button; IR Remote Control

8x8 HDMI 2.0 Matrix with Audio Matrix/ Downscaling/ AOC Supported
8
5.5 CLEAR Button
Please press the CLEAR button if want to withdraw an operation before the ENTER
button comes into effect, meanwhile, the matrix will return to the previous status.
6. IR Remote Control
The Matrix Switcher features one built-in IR receiver to receive IR signal from IR remote
to enable IR control. If the external IR receiver or other IR control device need to be
used, the IR EYE port on rear panel can be connected.
① Standby button:
Press it to enter/ exit standby mode.
② INPUTS:
Input channel selection buttons, same with the
corresponding front panel buttons
③ OUTPUTS:
Output channel selection buttons, same with the
corresponding front panel buttons.
④ Menu buttons:
⚫ ALL: Select all inputs/outputs.
To convert an input to all outputs:
Example: Input 1 to all Outputs:
→ Press INPUTS 1 + ALL + ENTER
⚫ EDID management button:
1) One input port follows the EDID data from one
output port.
Example: Input 2 learns EDID data from output 4:
→ Press EDID + INPUTS 2 + OUTPUTS 4+ ENTER
2) All input ports learn EDID data from one output
port.
Example: All input ports learn EDID data from output 3:
→ Press EDID + ALL + OUTPUTS 3 + ENTER
⚫ CLEAR: Withdraw button.
⚫ ENTER: Confirm operation.
INPUTS
OUTPUTS
MENU
1 2
3
4
5
6
7 8
1 2
3
4
5
6
7 8
ALL EDID
CLEAR ENTER
1
2
3
4