VivoLink VLHDMIMAT8X8 - EDID Management

8x8 HDMI 2.0 Matrix with Audio Matrix/ Downscaling/ AOC Supported
28
8.3.7 EDID Management
Command
Function
Feedback Example
EDIDMInit.
Restore the factory default EDID
data for each input.
All Input EDID Set Default!
System Initialization......
PTN1111
VLHDMIMAT8X8
V1.0.0
Power ON!
Front Panel UnLock!
EDIDUpgrade[x
x].
Upgrade EDID via Serial Port
⚫ [xx]=00~08
xx=01~08 is the number of the
port(able EDID user-defined for
corresponding HDMI input), if the
xx=00, it means all ports(able EDID
user-defined for all HDMI inputs).
Note: EDID user-defined can be
used once, if switch to another EDID
or exit, it will not be saved.
⚫ [xx]=U.
xx=U means user-defined for built-in
EDID(It can be saved in machine for
using at any time).
Note: It can user-defined only one
built-in EDID, after finishing it,
machine still use previous built-in
EDID.
When received commands, machine
will remind EDID file (.bin) to send
within 10 seconds.
Note: In order to guarantee the data
to be normal received, need to
disconnect all HDBaset before
sending the command(s)
File size: 256
Baud rate:115200bps
Quired time: About 0
second
Please wait...
Send Completed！User
Define EDID Upgrade OK
By RS232 Or GUI!
EDID/[xx]/[yy].
Input ports xx use built-in EDID yy
[xx]=00~08
xx=01~08 is the number of the input
port, if the xx=00, it means all input
ports.
Input All EDID Upgrade
OK By 09 Internal EDID!