VIVOTEK
48 - User's Manual
Note that the Preview button has been cancelled, all changes made to image settings is directly shown
on screen. You can click Restore to recall the original settings without incorporating the changes. When
completed with the settings on this page, click Save to enable the setting. You can also click on Prole
mode to adjust all settings above in a tabbed window for special lighting conditions.
Noise reduction
■ Enable noise reduction: Check to enable noise reduction in order to reduce noises and flickers in
image. This applies to the onboard 3D Noise Reduction feature. Use the pull-down menu to adjust
the reduction strength. Note that applying this function to the video channel will consume system
computing power.
3D Noise Reduction is mostly applied in low-light conditions. When enabled in a low-light condition
with fast moving objects, trails of after-images may occur. You may then select a lower strength level
or disable the function.
Enable to apply these settings at:
Select the mode this prole to apply to: Night mode or Schedule mode.
Please manually enter a range of time if you select the Schedule mode. Then check Save to take effect.
To Next Page
Loading...
