Vivotek FD8134V - Page 125

VIVOTEK
User's Manual - 125
nmotionprofile <positive integer> 0/7 Number of motion profiles.
ptzenabled <positive integer> 0/7 An 32-bit integer, each bit can be set
separately as follows:
Bit 0 => Support camera control function;
0(not support), 1(support)
Bit 1 => Built-in or external camera;
0(external), 1(built-in)
Bit 2 => Support pan operation, 0(not
support), 1(support)
Bit 3 => Support tilt operation; 0(not
support), 1(support)
Bit 4 => Support zoom operation;
0(not support), 1(support)
Bit 5 => Support focus operation;
0(not support), 1(support)
Bit 6 => Support iris operation;
0(not support), 1(support)
Bit 7 => External or built-in PT; 0(built-in),
1(external)
Bit 8 => Invalidate bit 1 ~ 7;
0(bit 1 ~ 7 are valid),
1(bit 1 ~ 7 are invalid)
Bit 9 => Reserved bit; Invalidate lens_pan,
Lens_tilt, lens_zoon, lens_focus, len_iris.
0(fields are valid),
1(fields are invalid)
eptz <positive integer> 0/7 A 32-bit integer, each bit can be set
separately as follows:
Bit 0 => stream 1 supports ePTZ or not.
Bit 1 => stream 2 supports ePTZ or not.
The rest may be deduced by analogy
npreset <positive integer> 0/7 Number of preset locations.
protocol_https < boolean > 0/7 Indicate whether to support HTTP over SSL.
protocol_rtsp < boolean > 0/7 Indicate whether to support RTSP.
protocol_sip <boolean> 0/7 Indicate whether to support SIP.
protocol_maxconnecti
on
<positive integer> 0/7 The maximum allowed simultaneous
connections.
protocol_maxgenconn
ection
<positive integer> 0/7 The maximum general streaming
connections .