Vivotek FD8167A - Using VIVOTEK Recording Software

VIVOTEK
User's Manual - 23
Using VIVOTEK Recording Software
A VAST recording software, allowing simultaneous monitoring and video recording for multiple
Network Cameras. Please install the recording software; then launch the program to add the
Network Camera to the Channel list. For detailed information about how to use the recording
software, please refer to the user’s manual of the software or download it from http://www.
vivotek.com.
1. If you forget the root (administrator) password for the camera, you can restore the camera
defaults by pressing the reset button for longer than 5 seconds.
2. If DHCP is enabled in your network, and the camera cannot be accessed, run the IW2 utility
to search the network. If the camera has been congured with a xed IP that does not comply
with your local network, you may see its default IP 169.254.x.x. If you still cannot find the
camera, you can restore the camera to its factory defaults. The factory default is DHCP client.
3. If you change your network parameters, e.g., added a camera via a connection to a LAN
card, re-start the IW2 utility.

Tips: