Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a paper clip or thin object� Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks� Note that
all settings will be restored to factory default� Upon successful restore, the status LED will blink
green and red during normal operation�
SD/SDHC Card Capacity
This network camera is compliant with SD/SDHC 32GB and other preceding standard SD cards�
SD/SDHC Card Slot
Recessed Reset
Button
Status LED
To Next Page
Loading...
