Vivotek FD8366-V - Page 228

VIVOTEK
228 - User's Manual
supporttriggertypes seq,boot,motion,net
workfail,recnotify,ta
mpering,vi,vadp,di,
volalarm,temperatu
re,pir, visignal,
backup,smartsd,
shockalarm
<product
dependent>
0/7 list all the trigger types which are supported in
the camera:
"seq" = Periodic condition
"boot" = System boot
"motion" = Video motion detection
"networkfail" = network connection failure
"recnotify" = Recording notification.
"tampering" = Tamper detection.
"vi" = Virtual input (Manual trigger)
"vadp" = VADP trigger
"di"= Digital input
"volalarm" = Audio detection
"temperature" = Temperature detection
"pir" = PIR detection
"visignal" = Video input signal loss.
"backup" = Backing up recorded files
"smartsd" = Lifetime detection of SD card
"shockalarm" = Shock detection
* Only available when [httpversion] >= 0301a
storage_dbenabled <boolean> 0/7 Media files are indexed in database.
protocol_https < boolean > 0/7 Indicate whether to support HTTP over SSL.
protocol_rtsp < boolean > 0/7 Indicate whether to support RTSP.
protocol_sip <boolean> 0/7 Indicate whether to support SIP.
protocol_maxconnection <positive integer> 0/7 The maximum number of allowed
simultaneous connections.
protocol_maxgenconnecti
on
<positive integer> 0/7 The maximum general streaming connections .
protocol_rtp_multicast_sc
alable
<boolean> 0/7 Indicate whether to support scalable multicast.
protocol_rtp_multicast_ba
ckchannel
<boolean> 0/7 Indicate whether to support backchannel
multicast.
protocol_rtp_tcp <boolean> 0/7 Indicate whether to support RTP over TCP.
protocol_rtp_http <boolean> 0/7 Indicate whether to support RTP over HTTP.
protocol_spush_mjpeg <boolean> 0/7 Indicate whether to support server push
MJPEG.
protocol_snmp <boolean> 0/7 Indicate whether to support SNMP.
protocol_ipv6 <boolean> 0/7 Indicate whether to support IPv6.