VIVOTEK
30 - User's Manual
Using VIVOTEK Recording Software
You can download a VAST recording software from VIVOTEKs website. The VAST software
allows simultaneous monitoring and video recording for multiple Network Cameras. Please
install the recording software; then launch the program to add the Network Camera to the Channel
list. For detailed information about how to use the recording software, please refer to the user’s
manual of the software or download it from http://www.vivotek.com.
1. If you forget the root (administrator) password for the camera, you can restore the camera
defaults by pressing the reset button for longer than 5 seconds.
2. If DHCP is enabled in your network, and the camera cannot be accessed, run the Shepherd
utility to search the network. If the camera has been congured with a xed IP that does not
comply with your local network, you may see its default IP 169.254.x.x. If you still cannot nd
the camera, you can restore the camera to its factory defaults. The factory default is DHCP
client.
3. If you change your network parameters, e.g., added a camera via a connection to a LAN
card, re-start the Shepherd utility.
Tips:
To Next Page
Loading...
Need help?
General
